Bathroom Hardware Installation Instructions

Bath Hardware

To install Bath Hardware, follow these steps:

Gather Tools: You will need a tape measure, pencil, drill, screwdriver, and level.

2"-#8 Screws with caps provided. If you are not mounting your hardware into a stud, anchors will be needed.

Measure and Mark: Determine the placement of the bath hardware by measuring and marking where the holes will go.

Pre-drill Holes: Use a drill to create holes at the marked locations.

Insert Screws: Drill pilot hole into the marked locations on the mounting surface.

Attach Hardware: Line up bath hardware with pilot holes. Hardware includes a screw, black washer, silver washer, and plastic cap to give the look of a rivet. First, drop the silver washer on the screw to cup up over the screwhead. Second, twist on the black washer in that same orientation (will sit between the mounting service and cap). Drill the screw into the mounting surface and tighten the screws with a screwdriver, being careful not to over-tighten. Finish by snapping the plastic cap onto the silver washer.

 

Back to blog